Wenzhou Zhengbang Electronic Equipment Co., Ltd.
No.19, Fengfang Road Ouhai economic and technological development area Wenzhou - Zhejiang – China
Wenzhou Head Office:
Serena (Foreign sales manager)
Thickness of placode
The height of wipe cutting
Rotating speed of blade
Lead rail travel route
Shape and dimension
1.External introduction 10. Blade gland bush
2. Main frame 11. Tool apron
3. Gear case 12. Push pedal hand shank
4. Power indicator 13. Lead rail cover
5. Power switch 14. Lead rail
6. Power wire . 15. Pin return board
7. Fuse base 16. Pin receiving tank
8. Earth terminator 17. Trundle
9. Lead rail cover adjusting screw
1. Open the package and read the instruction carefully and check the accessories (refer to term 7 in the instruction)
2. Check the body of machine for any abnormal phenomena, if so , contact the local agent as soon as possible
3. After conforming the good connection of the case earth, plug in.
4. First adjust the double lead rail travel route biggest, unscrew the gland bush screw(gland bush screw is right-handed screw )with 8# inner hexagonal wrench counterclockwise,take out the blade gland bush and clean up both sides of tool apron, blade, gland bush with clean and soft cloth. Then place gently the blade on the base(surface up). Next ,place the blade gland bush on the blade, screw down the gland bush screw with 8# inner hexagonal wrench clockwise. When unloading the blade, use the enclosed dismantled stick to fix the tool apron.
5. Rotate the adjusting hand wheel, adjust the width between the lead rails, and place one wanted placode of wipe cutting machine on the entrance and exit port respectively. Rotate the hand wheel until the placode at both ports slide properly in the lead rail.
6. Four sets(three screws per set)assembling screws that are equipped on top of lead rail bland bush are used to adjust the thickness of placode. During the adjusting first unscrew three perch screws among them and put placode inside and then adjust two lower order screws besides until they fit and screw down the middle screw. Operation are the same for four sets and adjust placode to slide properly inside the lead rail
7. Adjusting of height of wipe cutting machine : screw down lead rail retaining screw and adjust the big screw cap until the distance between blade and lead rail meets the requirement then screw down lead rail retaining screw. When adjusting lower avoid any friction between lead rail and blade for fear of damage to blade.
8. The height of wipe cutting of wipe cutting machine was adjusted as 1.5mm when it leaves factory and the thickness of textile board was adjusted as 1.2mm. When adjusting is necessary please adjust according to method mentioned above.
Notice: When the placode moves avoid moving too fast, and moving too fast can directly shorten the use life of blade and even endanger safety.
wipe cutting machine is the mechanic equipment of high accuracy and with high speed and the constant maintenance prolongs its use life
1. The rotating part needs constant lubrication.
2. Clean up the cut pin
3. If the transmitting triangle strap is damaged, it needs immediate replacement and the specification is (0-450)
4. The blade should not leave cutter head for too long, lubricate the cutter head when necessary if it leaves for several days.
2. This machine must work in the state of good earth connection
3. Cut off the power when installing or dismantling blade or in case of emergency
4. Cut off the power in sace of a blackout.
5. This machine should not be used in humid, flammable, corrosive, dense bug dust-filled environment.
6. Non professional repairmen are not allowed to dismantle the cover to repair it personally .
7. Do not open the cover when the machine rotates.
8. Operate the machine according to instruction strictly; otherwise out factory takes no responsibility.
2. Inner hexangular wrench one set
3. Triangle strap one
4. Guarantee, certification one
5. Dismantle knife pole one